Identification of relevant micropollutants in Austrian municipal wastewater and their behaviour during wastewater treatment

The European Union has defined environmental quality standards (EQSs) for surface waters for priority substances and several other pollutants. Furthermore national EQSs for several chemicals are valid in Austria. The study investigated the occurrence of these compounds in municipal wastewater treatment plant (WWTP) effluents. In a first screening of 15 WWTPs relevant substances were identified, which subsequently were monitored in 9 WWTPs over 1 year (every 2 months). Out of 77 substances or groups of substances (including more than 90 substances) 13 were identified as potentially relevant in respect to water pollution and subjected to the monitoring, whereas most other compounds were detected in concentrations far below the respective EQS for surface waters and therefore not further considered. The preselected 13 compounds for monitoring were cadmium (Cd), nickel (Ni), copper (Cu), selenium (Se), zinc (Zn), diuron, polybrominated diphenyl ethers (PBDEs), di(ethyl-hydroxyl)phthalate (DEHP), tributyltin compounds (TBT), nonylphenoles (NP), adsorbable organic halogens (AOX) and the complexing agents ethylenediaminetetraacetic acid (EDTA) as well as nitrilotriacetic acid (NTA). In the effluents of WWTPs the concentrations of the priority substances Cd, NP, TBT and diuron frequently exceeded the respective EQS, whereas the concentrations for DEHP and Ni were below the respective EQS. The effluent concentrations for AOX, EDTA, NTA, Cu, Se and Zn frequently are in the range or above the Austrian EQS for surface waters. Besides diuron and EDTA all compounds are removed at least partially during wastewater treatment and for most substances the removal via the excess sludge is the major removal pathway. For the 13 compounds which were monitored in WWTP effluents population equivalent specific discharges were calculated. Since for many compounds no or only few information is available, these population equivalent specific discharges can be used to assess emissions from municipal WWTPs to surface waters as well as to make a first assessment of the impact of a discharge on surface waters chemical status. Comparing discharges and river pollution on a load basis, the influence of diffuse sources becomes obvious and therefore should also be taken into consideration in river management.     

PRB强化垂直流人工湿地系统处理煤矿废水

针对常规人工湿地系统处理高浊含氮磷的有机煤矿废水不佳的问题,采用PRB与人工湿地耦合的方法,进行砂箱模拟实验研究。实验结果表明,由无烟煤、钢渣及沸石构建的PRB强化垂直流人工湿地系统对NH4+-N、PO34--P、Mn2+、COD、SS的去除率分别达到88.84%、96.08%、98.98%、85.78%和94.00%,与常规人工湿地相比,具有处理效率高、水力负荷大、占地面积小等特点,更便于运行管理。     

污水处理厂AB法工艺改造方案的探讨

针对漳州市东区污水处理厂AB法工艺改造的目标，分析了AB法工艺的局限性，结合该污水处理厂AB法工程的现有设施，从技术上探讨了5种具有脱氮除磷功能的工艺改造方案的可行性，并得到了适合于该污水处理厂AB法工艺改造的方案。     

活性污泥的耐盐驯化培养

以某污水处理厂二沉池好氧污泥为接种污泥,采用逐步提高盐度和稳定盐度2种方法对活性污泥进行耐盐性驯化培养,考察驯化结果表明,前一种方法更有利于耐盐菌的培养。对比不同盐度情况下各项指标的去除效果得出:本实验污泥适宜盐度为1%。使用稳定进水盐度的方法,出水指标及各指标的去除率均低于逐步提高盐度法,且镜检结果表明大量微生物死亡。     

陶瓷印花废水处理的混凝剂及工艺条件

采用混凝剂聚合氯化铝（PAC）、聚丙烯酰胺（PAM）、聚合硫酸铁（PFS）对陶瓷印花废水进行混凝沉降处理，监测水样的吸光度、浊度、悬浮物，以脱色率、浊度去除率、悬浮物去除率评价混凝处理的效果。结果表明：PAC是陶瓷印花废水沉降处理的理想混凝剂；水样的吸光度、浊度、悬浮物随混凝剂用量增大和沉降时间延长而呈降低趋势，而脱色率、浊度去除率、悬浮物去除率随混凝剂和沉降时间的增大呈增大的趋势；PAC投加量为20mg／L，沉降时间约为24h，水样脱色率达到90．0％，而当PAC投加量达到100mg／L，沉降时间约为4h，陶瓷印花水的脱色率可达到96．0％。证明了药剂用量的增加与沉降时间的延长对混凝过程具有增效作用。     

二级絮凝-活性炭处理实验室无机废水的效果

采用两级絮凝-活性炭吸附法处理实验室无机废水,研究了该方法对重金属、硫化物、挥发酚、苯胺和浊度等的处理效果。结果表明,在絮凝温度、搅拌、曝气及污水pH值调节范围一定的情况下,硫酸亚铁(FeSO4.7H2O)与聚合氯化铝(PAC)结合的二级絮凝方法能有效地降低污水中的重金属和硫化物等污染物。二级絮凝处理中,使用聚合氯化铝(PAC)对一级絮凝中去除效果不好的Cr6+的去除效果显著,去除率达到90%以上;活性炭对苯胺和硫化物的去除效果最佳,去除率都在90%以上。同时,该方法还有效降低了废水的浊度和色度。因此,是一种快速、低成本和工艺简单的处理实验室废水的有效途径。     

微电解预处理靛蓝牛仔布印染废水

靛蓝牛仔布印染废水组分复杂,浓度高、水量大,属于难处理的工业废水,为了有效降低后续生物处理单元的负荷,采用铁炭微电解工艺对该废水进行预处理；通过正交实验考察pH、反应时间及铁炭比处理效果的影响规律及COD去除反应动力学,并对各因素作了单因素影响实验,确定了最佳工艺条件.结果表明,铁炭微电解法是预处理靛蓝牛仔布印染废水的一种有效方法,在Fe/C为2:1、pH为3的条件下反应90 min,铁炭微电解出水COD的去除率在49.2％,色度去除率达到80％,该印染废水经微电解处理后,BOD5/COD比值可从原来的0.248上升至0.436,可生化性明显提高.此外,微电解预处理靛蓝牛仔布印染废水中COD的去除反应符合二级反应动力学规律.     

UASB-SBR-絮凝工艺处理地沟油制生物柴油废水

采用UASB-SBR-絮凝工艺处理地沟油制生物柴油废水，考察了各个阶段的废水处理效果。实验结果表明：UASB稳定运行阶段进水COD约为15000mg/L时，COD去除率约为87%，出水COD在2500mg/L以下，出水挥发性脂肪酸（VFA）浓度为4~6mmol/L，最佳容积负荷为15.0kg/（m3·d）；采用SBR处理UASB出水，当容积负荷为1.5kg/（m3·d）时，出水COD在200mg/L以下，COD去除率在83%以上，ρ（NH₃-N）在5mg/L以下，TP约为25mg/L。向SBR出水中加入质量分数为5%的聚合氯化铝进行化学除磷，加入量为5mL/L，处理后废水TP为4~6mg/L。处理后废水的COD，ρ（NH₃-N），TP均达到CJ343-2010《污水排入城市下水道水质标准》的A类要求。     

Integrated analysis of the effects of agricultural management on nitrogen fluxes at landscape scale

The integrated modelling system INITIATOR was applied to a landscape in the northern part of the Netherlands to assess current nitrogen fluxes to air and water and the impact of various agricultural measures on these fluxes, using spatially explicit input data on animal numbers, land use, agricultural management, meteorology and soil. Average model results on NH₃ deposition and N concentrations in surface water appear to be comparable to observations, but the deviation can be large at local scale, despite the use of high resolution data. Evaluated measures include: air scrubbers reducing NH₃ emissions from poultry and pig housing systems, low protein feeding, reduced fertilizer amounts and low-emission stables for cattle. Low protein feeding and restrictive fertilizer application had the largest effect on both N inputs and N losses, resulting in N deposition reductions on Natura 2000 sites of 10% and 12%, respectively.     

The Effects of Magnesium and Ammonium Additions on Phosphate Recovery from Greenhouse Wastewater

Phosphorus recovery from greenhouse wastewater, using precipitation-crystallization, was conducted under three levels of calcium concentration, 304 mg/L (7.6 mmol/L), 384 mg/L (9.6 mmol/L), and 480 mg/L (12 mmol/L), and also with additions of ammonium and magnesium into the wastewater. Jar test results confirmed high phosphate removal, with more than 90% of the removal achieved with a pH as low as 7.7. Under the low calcium concentration, ammonium addition affected the chemical reactions at pH lower than 8.0, where struvite was produced; when the pH was raised to 8.8, other calcium compounds dominated the precipitation. Under the medium calcium concentration, ammonium and magnesium addition helped struvite precipitation in the low pH range. Hydroxyapatite (HAP) was the main product. Under the high calcium concentration, ammonium addition showed no effects on the precipitation.